Toyota 2002 Camry - Page 947

H41415
H41416
Marks
60–26
–SUPPLEMENTAL RESTRAINT SYSTEM SPIRAL CABLE SUB–ASSY
2409Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
15. INSTALL SPIRAL CABLE SUB–ASSY
(a) Set the turn signal switch in neutral position.
NOTICE:
Make sure of the neutral position since the pin of the turn signal switch may be snapped.
(b) Engage the 3 claws and install the spiral cable sub–assy.
NOTICE:
When replacing the spiral cable sub–assy with new one, remove the lock pin before installing the
handle.
(c) Connect the airbag connector and connector.
(d) Install the steering column cover with the 2 screws.
16. CENTER SPIRAL CABLE
(a) Check that the ignition switch is OFF.
(b) Check that the battery negative terminal is disconnected.
NOTICE:
Do not start the operation for 90 seconds after removing
the terminal.
(c) Turn the cable counterclockwise by hand until it becomes
harder to turn.
(d) Then rotate the cable clockwise about 2.5 turns to align
the marks.
HINT:
The cable will rotate about 2.5 turns to both left and right of the
center.
17. INSTALL STEERING WHEEL ASSY
(See page 50–9)
Torque: 50 N⋅m (510 kgf⋅cm, 37 ft⋅lbf)
18. INSTALL HORN BUTTON ASSY
(See page 60–15)
Torque: 8.8 N⋅m (90 kgf⋅cm, 78 in.⋅lbf)
19. INSPECT HORN BUTTON ASSY
(See page 60–9)
20. INSPECT SRS WARNING LIGHT(See page 05–690)