H41432
H40008
Wire Harness
Diameter
Stripped Wire Harness Section
60–36
–SUPPLEMENTAL RESTRAINT SYSTEM INSTR PNL PASS L/DOOR AIR BAG ASSY
2419Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
CAUTION:
The instr pnl pass l/door airbag assy is very hot when
the airbag is deployed, so leave it alone for at least 30
minutes after deployment.
Use gloves and safety glasses when handling a instr
pnl pass l/door airbag assy with the deployed airbag.
When moving a vehicle for scrapping which has a
instr pnl pass l/door airbag assy with the deployed
airbag, use gloves and safety glasses.
Do not apply water, etc. to a instr pnl pass l/door air-
bag assy with the deployed airbag.
Always wash your hands with water after completing
the operation.
HINT:
When scrapping a vehicle, deploy the airbag and scrap the ve-
hicle with the instr pnl pass l/door airbag assy still installed.
2. DISPOSE INSTR PNL PASS L/DOOR AIR BAG
ASSY(WHEN DISPOSING OF AIRBAG ASSEMBLY
DEPLOYMENT METHOD)
NOTICE:
When disposing of the instr pnl pass l/door airbag
assy only, never use the customer’s vehicle to deploy
the airbag.
Be sure to follow the procedure given below when de-
ploying the airbag.
HINT:
Have a battery ready as the power source to deploy the airbag.
(a) Remove the instr pnl pass l/door airbag assy (See page
60–30).
CAUTION:
When removing the instr pnl pass l/door airbag assy,
work must be started 90 seconds after the ignition
switch is turned to the ”LOCK” position and the nega-
tive (–) terminal cable is disconnected from the bat-
tery.
Store the instr pnl pass l/door airbag assy with the air-
bag deployment side facing upward.
(b) Using a service–purpose wire harness for the vehicle, tie
down the instr pnl pass l/door airbag assy to the tire.
Wire harness: Stripped wire harness section
1.25 mm
2
or more (0.0019 in.
2
or more)
CAUTION:
If a wire harness which is too thin or some other thing is
used to tie down the instr pnl pass l/door airbag assy, it may
be snapped by the shock when the airbag is deployed. This
is highly dangerous. Always use a wire harness which is
at least 1.25 mm
2
(0.0019 in.
2
).
To Next Page
Loading...
