H40008
Wire Harness
Diameter
Stripped Wire Harness Section
H41548
Inner
Diam
Width
H41549
–SUPPLEMENTAL RESTRAINT SYSTEM CURTAIN SHIELD AIR BAG ASSY LH
60–47
2430Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
(c) Using a service–purpose wire harness for the vehicle, tie
down the curtain shield airbag assy to the tire.
Wire harness: Stripped wire harness section
1.25 mm
2
or more (0.0019 in.
2
or more)
CAUTION:
If the curtain shield airbag assy is tied down with too thin
wire harness, it may snap. This is highly dangerous. Al-
ways use a wire harness which is at least 1.25 mm
2
(0.0019
in.
2
).
HINT:
To calculate the square of the stripped wire harness section:
Square = 3.14 X (Diameter)
2
divided by 4
Position the curtain shield airbag assy LH inside the tire
with the airbag deployment side facing inside.
Tire size: Must exceed the following dimensions–
Width: 185 mm (7.28 in.)
Inner diameter: 360 mm (14.17 in.)
CAUTION:
Make sure that the wire harness is tight. It is very dan-
gerous if looseness in the wire harness results in the
curtain shield airbag assy LH coming free due to the
shock from the airbag deploying.
Always tie down the curtain shield airbag assy LH
with the airbag deployment side facing inside.
NOTICE:
The tire will be marked by the airbag deployment, so use a
redundant tire.
To Next Page
Loading...
