Commands
7-9
Command #30N se
lects the option of appending the time and date to transmitted IDs,
error messages, presence without tag reports, and input status change reports. The
factory default setting is time and date appended (command #302).
The reader returns an
Error message if its tag buffer contains data. The reset reader
command #63 may be transmitted to clear the buffer; however, tag ID data will not be
reported. If this is unacceptable, allow the buffer to empty before re-issuing append
time and date command #30N. Append Time and Date commands are shown in Table
7-4
Table 7-4 Append Time and Date Commands
Command Append Option
300 No time and date appended
302 Time and date appended (factory default)
The reader transmits messages with time and date appended as follows. One space
separates the time from the date.
<string>&<HH:MM:SS.hh MM/DD/YY>
where
string is a tag ID, error message, or report.
& separates <string> from the time and date.
HH:MM:SS is the
time delimiter.
MM/DD/YY is the
date delimiter.
Reader response:
Done
31N Append Auxiliary Information Selection
Command #31N selects the option of appending auxiliary information to transmitted
IDs, presence-without-tag reports, and input status change reports. Auxiliary informa-
tion is not appended to error messages. The fact
ory-default setting is no auxiliary
information appended. The N variable specifies whether or not auxiliary information
is to be appended. Append Auxiliary Information commands are shown in Table 7-5.
Table 7-5 Append Auxiliary Information Commands
Command Append Option
310 No auxiliary information appended (factory default)
311 Auxiliary information appended
To Next Page
Loading...
