Choosing, Installing, and Removing Tags
3-7
Figure 3-4 eGo Windshield Sticker Tag
eGo License Plate Tag
The eGo LPT (Figure 3-5) is a water-resistant tag used in applications requiring an
exterior-mounted tag.
Figure 3-5 eGo License Plate Tag
Installing eGo Plus Sticker Tags
eGo Plus Sticker Tags are designed to be attached by a semi-permanent adhesive to
the interior surface of nonmetallic windshields 0.190 to 0.230 inches (4.82 to 5.84
mm) in thickness. For optimum performance, you must install the tag at least 2 inches
(5 cm) from the metal in the windshie
ld frame and 0.75 inch (1.9 cm) from the rear-
view mirror support post. Detailed instructions for installing t
he eGo
®
Plus Sticker
Tag are found in the pocket guide “Quick and Easy Installation Instructions for the
eGo
®
Plus Sticker Tag.”
Some vehicles have a tinted area across the top of the windshield. If t
he tint is conduc-
tive, it can interfere with reading the
tag. If a windshield has this conductive tint, the
tag must be installed at least 2 inches (5 cm) below this tinted area.
To Next Page
Loading...
