TransCore encompass 4 - Alphabetical Command List

Command Quick Reference
D-17
Alphabetical Command List
The following conventions are used in Table D-3:
• Items in bold italics identify factory default settings.
• Only the command-related data portion of the reader message is shown.
Refer to Chapter 7, “Commands for the complete syntax of commands and messages.
Table D-3 Encompass 4 Reader Commands Listed Alphabetically
Command Name Code Reader Message
All IDs transmit 40 Done
Alternate fifth group select
disable
494 Done
Alternate fifth group select enable 495 Done
Alternate fourth group select
disable
492 Done
Alternate fourth group select
enable
493 Done
Alternate group select disable 496 Done
Alternate group select enable 497 Done
Alternate second group select
disable
458 Done
Alternate second group select
enable
459 Done
Alternate third group select
disable
490 Done
Alternate third group select
enable
491 Done
Appended info status display 524 IDAP T1 D1 X0 
T0 = time not appended
T1 = time appended
D0 = date not appended
D1 = date appended
X0 = aux info not appended 
X1 = aux info appended
ATA disable 480 Done
ATA enable 481 Done if Encompass 4 Reader
model supports this tag protocol.
Error if tag protocol is
unsupported.