TransCore encompass 4 - Display Communications Protocol Status

Commands
7-21
Encompass 4 Reader.
Reader message:
IDAP T<0> D<0> X<0 to 1>
where
T0 Time not appended
T1 Time appended (not valid for the Encompass 4 Reader)
D0 Date not appended
D1 Date appended (not valid for the Encompass 4 Reader)
X0 Auxiliary information not appended (factory default)
X1 Auxiliary information appended
One space is required between each value. For example, if factory-default settings are
assigned, the reader response is
IDAP T0 D0 X0
indicating time, date, and auxiliary information not appended.
525 Display Communications Protocol Status
Command #525 displays the status of command #61N Selected Communications
Protocol, command #614N Selected Mode of Flow Control, and command #612NN
ECP Timeout.
Reader response:
ECPS P<0 to 2> T<01 to FF> X<0 to 2> S0
where
P0 Basic protocol enabled (factory default)
P1 ECP enabled
P2 data inquiry protocol enabled
Txx ECP timeout where xx = 01 to FE (hexadecimal)
Timeout (ms) = 50 * xx
If xx = FF timeout disabled
X0 Flow control disabled
X1 Software flow control enabled (factory default)
X2 Hardware flow control enabled
S0 start of message character is #