Encompass 4 Reader System Guide
7-28
532 Display Wiegand Mode Status
Command #532 displays the Wiegand mode status as either enabled or disabled.
Reader message:
TOF <0 to 1>
where
0 Wiegand mode disabled
1 Wiegand mode enabled
533 Display Wiegand Retransmit Interval
Command #533 displays the Wiegand retransmit interval. This interval specifies the
delay in seconds before the reader retransmits Wiegand data for a tag still in the read
zone. The factory default is 1 second.
Reader message:
WTI <01 to FF>
where 01 to FF = seconds (1–255) in hexadecimal.
Note: The actual value of the Wiegand retransmit interval may vary depending on the
operative tag read mode and the type of tag in the read field.
For example, 10 = 16 seconds and FF = 255 seconds. The retransmit interval in ATA
tag read mode is about twice these values.
534 Display Tag Translation Mode Status
Command #534 displays tag translation mode status, enabled or disabled. If tag
translation mode is enabled, incoming full-frame tags in AAR or ATA format are
translated according to ISO standards. Refer to
“452 Disable Tag Translation Mode
(Factory Default)” on page 7-13 and “453 Enable Tag Translation Mode” on page 7-
13 for more information.
Reader message:
TT <0 to 1>
where
0 tag translation mode disabled
1 tag translation mode enabled
537 Display Echo Status
Command #537 displays echo mode status. In basic protocol (#610 Select Basic
Protocol), the reader may be configured to enable (#6171 Enable Echo Mode) or dis
-
able (#6170 Disable Echo Mode) the echo of received commands. Refer to sections
6170 Disable Echo Mode and “6171 Enable Echo Mode (Factory Default)” on page 7-
33 for more information.
To Next Page
Loading...
