Choosing, Installing, and Removing Tags
3-15
Figure 3-15 Upper Placement Over the Top Area of the License Plate
Installing eGo Windshield Sticker Tags
eGo WSTs are designed to be attached by a semi-permanent adhesive to the interior
surface of nonmetallic windshields 0.190 to 0.230 inches (4.82 to 5.84 mm) in thick-
ness. For optimum performance, you must install the tag at lea
st 2 inches (5 cm) from
the metal in the windshield frame and 0.75 inch (1.9 cm) from the rearview mirror
support post. Detailed instructions are found in the pocket guide “Quick and Easy
Installation Instructions for Windshield Sticker Tag.”
Some vehicles have a tinted area across the top of the windshield. If t
he tint is conduc-
tive, it can interfere with reading the
tag. If a windshield has this conductive tint, the
tag must be installed at least 2 inches (5 cm) below this tinted area.
Some vehicle windshields contain a metallic treatment
that could prevent an interior
windshield-mounted tag from being read. However, many of these metallized wind-
shields have areas that are not
metallized. On a vehicle without open areas in its met-
allized windshield, you might need to insta
ll an Encompass 4 Reader-compatible LPT
on the vehicle. See the section “Installing eGo Plus License Plate Tags” on page 3-13
and the section “Installing ATA License Plate Tags” on page 3-21. Contact TransCore
for more information.
See the section “Technical Support” on page 9-7.
To Next Page
Loading...
