TransCore encompass 4 - Numerical Command List

To Next Page

To Previous Page

Command Quick Reference

D-5

Numerical Command List

The following conventions are used in Table D-2:

• Items in bold italics identify factory default settings.

• Only the command-related data portion of the reader message is shown.

Refer to Chapter 6, “Communications Protocols for the complete syntax of commands

and messages.

RF timeout Never true 693F

Input inversion Disabled 6940

Input status change reports Disabled 820

Automatic periodic RF status

report

Disabled 830

Table D-1 Encompass 4 Reader Default Configuration Settings (continued)

Parameter Setting Command

Table D-2 Encompass 4 Reader Commands Listed Numerically

Number Command Name Reader Message

00 Switch to data mode Done

01 Switch to command mode Done

1002 Set baud rate = 1200 baud Done

1003 Set baud rate = 2400 baud Done

1004 Set baud rate = 4800 baud Done

1005 Set baud rate = 9600 baud Done

1006 Set baud rate = 19.2 K baud Done

1007 Set baud rate = 38.4 K baud Done

1010 Use one stop bit Done

1011 Use two stop bits Done

1020 Disable parity Done

1021 Select even parity Done

1022 Select odd parity Done

Other manuals for TransCore encompass 4