TransCore encompass 4 - Display RF0 Filter Status

Commands
7-27
TE 752 ms
TF RF timeout infinite, never expires (factory default)
I0 input inversion disabled (factory default)
I1 input inversion enabled
For example, if factory default settings are assigned, the reader message is
PRST P0 D0 A2 TF I0
which means that presence without tag reports is disabled, minimum presence true
period is 0, RF off control on timeout or presence false, infinite RF timeout, and input
inversion disabled.
530 Display RF0 Filter Status
Command #530 displays the parameter set for the RF input, including the selected
unique ID code criteria (#410N Select Unique ID Code Criteria) and the valid ID code
criteria (see #420N Select Valid ID Code Criteria).
Reader message:
RF0S U<0 to 4> V<0 to 3>
where
U0 One ID separation (factory default)
U1 Two ID separations
U2 Three ID separations
U3 Four ID separations
U4 Transmit all IDs
V0 Valid ID code criteria of one acquisition
V1 Valid ID code criteria of two acquisitions
V2 Valid ID code criteria of three acquisitions
V3 Valid ID code criteria of four acquisitions
For example, if factory default settings are assigned, the reader message is
RF0S U0 V0
which means separation of one ID for uniqueness filtering and a valid ID code criteria
of one acquisition.