Encompass 4 Reader System Guide
D-16
693N Set RF timeout N = 0–F
(always expired, 4,8,12,20,24,
32,48,60,92,152, 300,452,
600,752, infinite)
Done
693F Set RF timeout to infinite Done
6940 Disable input inversion Done
6941 Enable input inversion Done
695S...S Set serial number
S...S = ASCII string
(maximum length of 6
characters)
Done
696S...S Store hardware
configuration string
S...S = ASCII string
(maximum length of 20
characters)
Done
697 Set user-programmable group
select equals (GSE) filter
697
MM AA DDDDDDDDDDDDDDDD
where
MM = determines which of the
eight comparison data bytes are
to be compared for the Group
Select filter
AA = determines the start ad-
dress in the tag memory for the
comparison data
D...D = 8-byte field (16 charac-
ters) used by the tag as the com-
parison data for the group select
filter
Done
820 Disable input status change
reports
Done
821 Report change on input0 Done
822 Report change on input1 Done
823 Report changes on both Done
830 Disable automatic periodic RF
status report
Done
831 Enable automatic periodic RF
status report
Done
Table D-2 Encompass 4 Reader Commands Listed Numerically (continued)
Number Command Name Reader Message
To Next Page
Loading...
