Command Quick Reference
D-15
645NN Set eGo or eGo Plus operating
range NN = 00 (shortest) to
1F (longest)
Done
6451F Set eGo or eGo Plus operating
range to longest range
Done
646XX Set IAG RF attenuation
XX = 00 to 0F
Done
647XXX Select RF operating frequency
from 860 to 930 in 250 kHz steps
XXX = 000 to 118 (hexadecimal)
Done
648NN Set synchronization output delay
time NN = 01 to FF, where 01 = 1
ms and FF = 255 ms.
Done
64800 Disable synchronization output
delay
Done
649NN Set synchronization hold-off time
NN = 01 to 0A, where 01 = 1 ms
and 0A = 10 ms.
Done
64900 Disable synchronization hold
off time
Done
65 Reset power fail bit Done
66F Load default operating
parameters (except RF operating
frequency)
Done
67N
Set output pulse duration N = 0 to F
(4,8,12,16,20,24,32,40,48,60,76,
152, 228,300,376,752 ms)
Done
67C Output pulse duration set to
228 ms
Done
6900 Disable presence without tag
reports
Done
6901 Enable presence without tag
reports
Done
6920 Turn RF off on timeout Done
6921 Turn RF off on timeout/tag Done
6922 Turn RF off on
timeout/no presence
Done
Table D-2 Encompass 4 Reader Commands Listed Numerically (continued)
Number Command Name Reader Message
To Next Page
Loading...
