TransCore encompass 4

To Next Page

To Previous Page

Encompass 4 Reader System Guide

D-14

612NN Set ECP timeout

NN = 01–FE (1–255)

timeout = 50 ms * NN

(if NN = FF, timeout is disabled)

Done

612FE Set ECP timeout = 12.7 sec Done

613 Enable data inquiry protocol Done

6140 Disable flow control Done

6141 Enable software flow control Done

6142 Enable hardware flow control Done

6170 Disable echo Done

6171 Enable echo Done

6200 Turn both outputs off Done

6201 Turn output0 on Done

6202 Turn output1 on Done

6203 Turn both outputs on Done

621 Select predefined output mode Done

63 Reset reader Model [model] 

Ver [version no.] SN [serial no.]

TransCore

6400 Turn off RF Done

6401 Turn on RF Done

641 Select RF-by-input control Done

642NN Select RF operating frequency Done

643NN Set ATA operating range

NN = 00 (shortest) to 1F (longest)

Done

6431F Set ATA operating range to

longest range

Done

644NN Set RF attenuation NN = 00 to 0A Done

64400 Set RF attenuation to 0 dB (full

power)

Done

Table D-2 Encompass 4 Reader Commands Listed Numerically (continued)

Number Command Name Reader Message

TransCore encompass 4 - Page 278