TransCore encompass 4 - Page 277

Command Quick Reference
D-13
534 Display tag translation mode
status
TT <0 to 1> 
0 = tag translation mode
disabled

1 = tag translation mode
enabled
537 Display echo status ECHO x
0 = disabled
1 = enabled
540 Display flash checksum PCKS I0000 Exxxx
xxxx = 4-byte ASCII checksum
543 Display boot checksum BCKS xxxx 
xxxx = 4-byte ASCII checksum
549 Display user-programmable
group select equals (GSE) filter
data
The response data is formatted
similar to the data in the config
-
uration command.
560 Display input status change SSTC Ex Mx 
E0 = status change reports
disabled 
E1 = status change reports
enabled

M0 = no reporting 
M1 = report change on input0
M2 = report change on input1
M3 = report change on either
input
570 Display tag protocols ATA:<E, D> eGo:<I, F, D>
SeGo:<I, F, D> IAG:<E, D>
Sort:<E, D>

I = ID (64 bits)
E = Enabled
F = Full transaction (eATA)
D = Disabled
577 Report buffered handshakes XX = number of handshakes
582 Display synchronization values SYNC T<00 to FF> H<00 to 0A>
60NN Set reader ID number 
NN = 00 to FF
Done
6000 Set reader ID number to 00 Done
610 Select basic protocol Done
611 Select ECP protocol Done
Table D-2 Encompass 4 Reader Commands Listed Numerically (continued)
Number Command Name Reader Message