Sending Functions
2-30 ADVANCED OPERATION GUIDE
Enter Document Name/File Name
Add document name as well as Job No. and date to the scanned image.
You can specify the default for a document name.
1
Press the Send key.
2
Press [Advanced Setup] and then [File Name Entry].
3
Press [File Name].
4
Enter the document name, and press [OK].
NOTE: Up to 30 characters are available for the document name.
5
Press [Job No.] to enter the job No., and [Date and Time] to enter the date.
6
Press [OK].
7
Specify the destination, and press the Start key to start sending.
Status 10/5/2006 10:10
Enter Destination.
Cancel OKAdd Shortcut
Ready to send.
Add a file name.
Additional information such as [Job No.]
and [Date and Time] can also be set.
File Name Entry
Destination
File Name
doc
Additional Info.
Job No.
Date and Tim e
1
& [Date and Time ]
To Next Page
Loading...
