Security
8-4 ADVANCED OPERATION GUIDE
Touch Panel Display after the Security Kit Installed
Hard Disk Icon Display
In Security Mode,
the Security Kit
should be properly
installed and run.
The hard disk icon
appears on the
lower right side of
the touch panel in
Security Mode.
NOTE: If the hard disk icon does not appear on the normal screen, it
could be possible that the Security Mode is not ON. Call service.
How hard disk icon display changes during overwriting
CAUTION: Do not turn the main power switch off during overwriting (while
are displayed). It may crash the hard disk.
NOTE: If you accidentally turn the main power switch off during
overwriting or initialization, the hard disk icon might not switch to HD
ICON2. It should be caused by the possible crash or failed overwriting of
the data, which must have been overwritten. This would not affect
subsequent overwriting processes. However, system initialization should
be recommended to return to the normal stable operations. (Initialization
should be performed by the administrator following the steps in System
Initialization on page 8-8.)
Status 10/5/2006 10:10
Original
Zoom
Paper
100%
- - -
:
:
:
- - -
Image
Quality
Ready to copy.
Set Original.
Copies
Copy Image
Org./Paper/
Finishing
Quick Setup Layout/Edit Adv anced
Setup
1
Normal 0
Zoom Density Paper
Selection
1-sided
>>1-sided
Tex t+Photo Col late
Duplex Original
Image
Collate/
Offset
Auto
Plain
A4
Icon displayed Description
There is unwanted data on the hard
disk.
Overwriting the unwanted data
The unwanted data overwritten.
To Next Page
Loading...
Need help?
General
