Utax CD 1230 User Manual

System Menu
ADVANCED OPERATION GUIDE 6-51
8
Check if all the address entries are correct and press [OK].
9
Press the Power key and confirm that the Power key/indicator and the
memory indicator are off. After that, turn the main power switch off and on.
TCP/IP Setup (Equipped with DHCP Server)
Set up TCP/IP when the network is equipped with the DHCP server. The
machine works as the DHCP client.
1
Press the System Menu key.
2
Press [System], [Next] of Network and then [Change] of TCP/IP.
3
Press [On] on the
left side of the touch
panel.
4
Press [On] of DHCP.
5
Press [OK].
6
Press the Power key and confirm that the Power key/indicator and the
memory indicator are off. After that, turn the main power switch off and on.
Netware Setup
Select the NetWare network connection. After that, select frame types for
NetWare network from Auto, Ethernet-II, 802.3, 802.2, or SNAP.
1
Press the System Menu key.
2
Press [System], [Next] of Network and then [Change] of NetWare.
System - TCP/IP
Use TCP/IP.
On
Off
Cancel OK
Status 10/5/2006 10:10
DHCP
On
Off IP Address
Subnet Mask
Default
Gateway
0.0.0.0
0.0.0.0
0.0.0.0

Utax CD 1230 Specifications

General

Brand	Utax
Model	CD 1230
Category	All in One Printer
Language	English