Security
ADVANCED OPERATION GUIDE 8-9
Warning Message
If the encryption
code information of
the machine has
been lost for some
reason, the screen
below appears when
the power is turned
on.
1
Press [Encryption Code], and enter the encryption code that was entered
during the installation of the Security Kit.
CAUTION: Even though the entry of a different encryption code could
also enable to continue the job, the data stored in the hard disk would be
all erased. You should be careful enough about this.
2
Press the Power key and confirm that the Power key/indicator and the
memory indicator are off. After that, turn the main power switch off and on.
Enter the encryption code.
OK
Encryption
Code
To Next Page
Loading...
Need help?
General
