Sending Functions
2-32 ADVANCED OPERATION GUIDE
Finish Notice
Informs that the sending is completed by an E-mail.
1
Press the Send key.
2
Press [Advanced Setup] and then [Job Finish Notice]
3
When selecting the
destination from
Address Book,
press [Address
Book].
4
Specify the destination of sending the finish notice, and press [OK].
NOTE: For the procedure to select the destination from the address
book, refer to the Operation Guide.
5
To directly enter the
address, press
[Address Entry] and
then [E-mail
Address].
6
Enter the E-mail address, and press [OK].
7
Press [OK].
8
Specify the destination, and press the Start key to start sending.
When the sending is completed, the finish notice is sent to the specified E-
mail address.
Status 10/5/2006 10:10
Ready to send.
Cancel OK
Job Finish Notice
Add Shortcut
Address
Entry
Destination
Address Book
Off
Detail
Detail Address Book
Destination
1
Place original.
Status 10/5/2006 10:10
Ready to send.
Cancel OK
Job Finish Notice
Add Shortcut
Address Book
Address
Entry
Off
E-mail
Address
Destination
1
Place original.
To Next Page
Loading...
