Copying Functions
1-24 ADVANCED OPERATION GUIDE
Margin/Centering Mode
Shift the original image to make space on the copy for binding on the left
(right) or top (bottom) side.
When you copy onto paper different from the original size, you can center
the original image on the paper.
The following margin widths are available.
Margin on the Back Side
When duplex copying, you can also specify the margin on the back side.
Auto
When Auto is specified, the left and right margins on the front are reversed
on the back. For example, if the left margin on the front is 10 mm, the right
margin on the back will be 10 mm. The top and bottom margin widths on
the back will match those on the front.
Separate Front/Back Margins
Enables you to specify the front and back settings separately.
NOTE: You can set the default margin width. Refer to Margin Default on
page 6-28 for details.
1
Press the Copy key.
2
Press [Layout/Edit] and then [Margin/Centering].
3
Press [Margin] to select the copy with margin.
Use [+] or [–] to enter the margins for Left/Right and Top/Bottom. Press [#
Keys] to use the numeric keys for entry.
Model Margin Width
Inch Models -0.75 to 0.75" (in 0.01" increments)
Metric Models -18 mm to 18 mm (in 1-mm increments)
To Next Page
Loading...
Need help?
General
