Copying Functions
1-16 ADVANCED OPERATION GUIDE
Output Destination
Specify the optional document finisher tray or any other specific tray as the
output destination for finished copies.
NOTE: Optional output destinations include the job separator, document
finisher, 3000 Sheet Document Finisher and the mailbox.
NOTE: To change default destination for copies, refer to Output Tray on
page 6-19 for details.
1
Press the Copy key.
2
Press [Org./Paper/Finishing] and then [Output Tray].
3
Select the output destination for finished copies.
When you select any
of [Finisher tray],
[Tray B], [Tray C] or
[Trays 1 to 7], select
the orientation of
output copy, Face
Up (print facing up)
or Face Down (print
facing down).
4
Press [OK].
Destination Description
Top tray Top tray of the machine (where copies are
stored)
Finisher tray*
* Copy output orientation can be selected either as face-up (print
facing up) or face-down (print facing down).
Tray of the optional document finisher or built-in
finisher
Tray A, Tray B*,
Tray C*
Tray A to C of the optional 3000 Sheet
Document Finisher
Job separator tray Optional job separator
Trays 1 to 7* Trays 1 to 7 of the optional mailbox (Tray 1 is the
top tray)
Status 10/5/2006 10:10
Ready to copy.
Copies
Cancel OK
Output Tray
Press [OK] to display
Add Shortcut
Tray BTray A
Face Up
Face Down
Top Tray Tray C
Job Separator
Tray
Tray 1 Tray 2 Tray 3
Tray 4 Tray 5 Tray 6 Tray 7
1
the image.
To Next Page
Loading...
Need help?
General
