System Menu
6-60 ADVANCED OPERATION GUIDE
Drum Refresh
Execute drum refresh when print is blurred.
NOTE: Drum Refresh cannot be performed while printing. Execute Drum
Refresh after the printing is done.
1
Place A4-R on the Multi Purpose tray.
2
Press the System Menu key.
3
Press [T], [Adjustment/Maintenance] and then [Execute] of Drum Refresh.
4
Press [Yes]. Drum
Refresh starts and
ends in about 6
minutes.
5
Once Drum Refresh ends, return to the Adjustment/Maintenance screen.
Correcting Fine Black Line
Correct fine black lines (black streaks caused by contamination), which
may appear on the copies, when the optional document processor used.
If black lines appear from the top to the bottom edge, refer to Charger Auto
Cleaning on page 6-61.
Adjustment/Maintenance
Status 10/5/2006 10:10
Copy Density Adjustment: Change
Close
Change
Execute
Execute
Send/Box Density Adjust.:
Change
Print Density:
Correcting Black Line:
Display Brightness:
Char ger Auto Cleaning:
Yes
Drum Refresh will be started.
Are you sure?
No
To Next Page
Loading...
Need help?
General
