369
Application Protocol
Connected Serial Port
IP Address Allocation
Unique Identier
Status Indicator
Interface
Physical Transport Layer
Transport Protocol
Specification about the Ethernet
TCP (Client / Server) , UDP (Client / Server)
CH1
The media access control address (MAC address) is used
LINK (green, ON when physical link is established); Data (yellow, blink when data is transferring)
Ethernet RJ-45 jack
10BASE-T / 100BASE-TX
Transparent or conversion MODBUS TCP to MODBUS RTU
Automatic by DHCP server or Static (manual) allocation
Comm. Parameter Modify
Use the specic conguration software
Item
RS-485 RS-485
CH1 CH2
TX (transmitting) and RX (receiving)
Half-duplex
By the setting of installed project (115,200 bps. Max.)
By the installed project (via the "COM Port setting" page in the programming software)
Fixed 5mm Screw-Clamp Terminal Block
Item
Specification about Communication Ports
Communication Interface
Isolation Method
Communication Indicator
Max. Communication
Communication Method
Baud Rate
Power Consumption
Wiring Method
Parameter Conguration
No isolation No isolation
TX (transmitting) and RX (receiving)
50 M 50 M
Half-duplex
Fixed 5mm Screw-Clamp Terminal Block
Ethernet DC5V 100mA + RS-485 ports DC5V 100mA (total is 200mA from PLC Main Unit)
The VS-ENET-EC Communication Expansion Card is a dual port card. It offers one Ethernet port (with an additional
non-isolated RS-485 interface) and one non-isolated RS-485 port.
By way of the parameter setting and well planned program at the VS Series PLC Main Unit, each port can separately
perform one of various communication functions.
VIGOR LOGO
30mm
64mm
25mm 15mm
1807-
0001
VS-ENET-EC
VIGOR
CH1
CH1
RX TX
CH2
SG
DD
ENET
RX TX
D
D
CH2
RS-485 RS-485
ETHERNET
RJ-45 Ethernet Jack
Serial Number
Complete
Model Name
Manufacturer
Expansion Card
Connector
Product Exterior
Fix Clip (upper)
Brief Model Name
Communication
Status Indicator
CH2 Communication
Connecting Terminal
Fix Clip (lower)
Product Specification
1
ON
7-2-8 VS-ENET-EC Communication Expansion Card