Vigor VS Series User Manual

LD
ORI
LD
AND
LDI
ANI
ORB
OR
ANB
OR
OUT
X20
X21
X22
X23
X24
X25
X26
X27
Y0
OR
LD
OR
ANB
OUT
LD
AND
LD
AND
ORB
OUT
LD X0
X1
X2
X3
Y0
X4
X5
X6
X7
M0
ANB
(AND BLOCK)
ORB
(OR BLOCK)
X0 X2
Y0
M0
X1 X3
X4
X6 X7
X5
X20 X22 X23
Y0
X21 X24 X25
X27
X26
83
Series connection of multiple
parallel circuit blocks
Parallel connection of multiple
contact circuit blocks
3-4 The ANB and ORB Instructions
Initial logical operation contact type NO (Normally Open)
Parallel connection of NO (Normally Open) contact
Initial (the starting point of another circuit block) logical
operation contact type NO (Normally Open)
Parallel connection of NO (Normally Open) contact
Series connection of multiple parallel circuit blocks
Final logical operation type coil drive
Initial logical operation contact type NO (Normally Open)
Serial connection of NO (Normally Open) contact
Initial (the starting point of another circuit block) logical
operation contact type NO (Normally Open)
Serial connection of NO (Normally Open) contact
Parallel connection of multiple contact circuit blocks
Final logical operation type coil drive
To declare the starting points of the circuit block, please use an LD, LDI, LDP or LDF instruction. After completing the
serial circuit block, to connect it to the preceding block by series/parallel connection should use the ANB/ORB instruction.
No more than 8 of the ANB and ORB instructions in a batch circuit.
Please refer to the following program example, it is used both the ANB and ORB instructions in a circuit block.
Mnemonic Devices Function Format
Ladder Diagram Instruction List
Ladder Diagram
Instruction List

Vigor VS Series Specifications

General

Brand	Vigor
Model	VS Series
Category	Controller
Language	English