Vigor VS Series - 3 Basic Instruction; Basic Instruction Table

MPS
MPP
MRD
PLF
(PULSE FALLING)
PLS
(PULSE)
LD
(LOAD)
LDI
(LOAD INVERSE)
Initial logical operation contact type NO
(Normally Open)
Initial logical operation contact type NC
(Normally closed)
Initial logical operation Rising edge pulse
Initial logical operation Falling edge pulse
Serial connection of NO
(Normally Open) contact
Serial connection of NC
(Normally Closed) contact
Serial connection of Rising edge pulse
Serial connection of Falling edge pulse
Parallel connection of NO
(Normally Open) contact
Parallel connection of NC
(Normally Closed) contact
Parallel connection of Rising edge pulse
Parallel connection of Falling edge pulse
Series connection of multiple parallel
circuit blocks
Parallel connection of multiple contact
circuit blocks
Store the current result of the internal
PLC operation
Read the current result of the internal
PLC operation
Pop (recall and remove) the currently
stored result
Invert the current result of the internal
PLC operation
Conversion of operation result to
Rising edge pulse
Conversion of operation result to
Falling edge pulse
Final logical operation type coil drive
Set component permanently ON
Reset component permanently OFF
Rising edge pulse
Falling edge pulse
X, Y, M, S, T, C, D.b, R.b
X, Y, M, S, T, C, D.b, R.b
X, Y, M, S, T, C, D.b, R.b
X, Y, M, S, T, C, D.b, R.b
X, Y, M, S, T, C, D.b, R.b
X, Y, M, S, T, C, D.b, R.b
X, Y, M, S, T, C, D.b, R.b
X, Y, M, S, T, C, D.b, R.b
X, Y, M, S, T, C, D.b, R.b
X, Y, M, S, T, C, D.b, R.b
X, Y, M, S, T, C, D.b, R.b
X, Y, M, S, T, C, D.b, R.b
LDP
(LOAD PULSE)
LDF
(LOAD FALLING PULSE)
AND
(AND)
ANI
(AND INVERSE)
ANDP
(AND PULSE)
ANDF
(AND FALLING PULSE)
OR
(OR)
ORI
(OR INVERSE)
ORP
(OR PULSE)
ORF
(OR FALLING PULSE)
ANB
(AND BLOCK)
ORB
(OR BLOCK)
MPS
(POINT STORE)
MRD
(POINT READ)
MPP
(POINT POP)
INV
(INVERSE)
MEP
MEF
OUT
(OUT)
Y0
SET
(SET)
Y0
SET
Y, M, S, T, C, D.b, R.b
Y, M, S, D.b, R.b
RST
(RESET)
RST
Y0
Y, M, S, D.b, R.b, T, C, D, R, V, Z
Y, M(Except for special M)
Y, M(Except for special M)
Y0
PLS
Y0
PLF
79
3. Basic Instruction
3-1 Basic Instruction Table
Mnemonic Format Devices Function