Operation0230−1/A1
Winterthur Gas & Diesel Ltd.
2/ 2
3.2 Engine Start Procedure
1) In the LDU, MAIN page push the button ON/OFF to start the auxiliary blowers.
Make sure that Running shows in the Auxiliary Blowers field (see 4002−2,
paragraph 3.3 MAIN page).
2) Use the rotary button to select the Fuel command button.
3) Turn the rotary button to set the fuel injection quantity to approximately 30%.
4) Push the button START AHD or START AST until the engine operates.
5) Slowly turn the rotary button to adjust the fuel injection quantity until the engine
operates at the applicable speed. You can see the related value on the display
and speed indicator.
6) Read the instructions to increase the speed/power (see 0260−1 Maneuvering)
and monitor the data (see 0250−1 Operating Data Sheet).
You can also do the engine start procedure above from the ECR manual control
panel.
Note: You can use the buttons and rotary button only at the related active
control stand (see 4002−2, paragraph 3.4 Control locations).
Engine Start
2014
To Next Page
Loading...
