Woodward DSLC-2 - Control Status Monitor

Manual 37443A DSLC-2 - Digital Synchronizer and Load Control
© Woodward Page 103/226
Menu 8 – Control Status Monitor
This menu contains the parameters of the control status monitor of the DSLC-2 showing the actual modes, refer-
ences and alarms.
Figure 3-33: ToolKit – control status monitor
ID
Parameter
CL
Setting range
Format
Description
4602
Synchronizer
mode
-
Off /
Synchronized /
Permissive /
Check /
Run /
Sync Timer /
Auto-Off /
Close Timer
-
Display of the different Synchronizer modes:
Off: The synchronizer is not active.
Synchronized: The GCB is closed.
Permissive: The synchronizer runs in permissive mode.
Check: The synchronizer runs in check mode.
Run: The synchronizer is full active.
Sync Timer: The synchronizer is stopped, because of a sync
time-out.
Auto-Off: The synchronizer is stopped, because of an unsuccess-
ful closure of the GCB. (resync is disabled).
Close Timer: This is the GCB close command.