Manual 37443A DSLC-2 - Digital Synchronizer and Load Control
© Woodward Page 213/226
Appendix D.
Parameter Overview
Introduction
≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡
Parameter List Columns
The parameter list consists of the following columns, which provide important information for each parameter:
Namespace X
The namespaces 1 and 2 are used to combine all parameters within functional groups.
ID
The parameter ID is a unique identifier for each individual parameter. It is mentioned besides each parameter in
ToolKit and also required when configuring the unit via interface.
Parameter Text
The parameter text describes the parameter and appears on the configuration screens of the unit and ToolKit.
Setting Range
The setting range describes the range for possible parameter settings and may either be a range (e.g. 0 to 9) or a
selection of different options (e.g. Yes or No). If the respective parameter allows configuring different options,
the number behind each option is the number, which needs to be transmitted via interface to select this option.
Default Value
The default value is the parameter setting at delivery of the unit or after resetting the unit to factory settings. If the
parameter allows configuring different options, the default value describes the number of the respective option.
Data Type
The data type indicates the data type of the respective parameter. The following data types are possible:
• UNSIGNED8 unsigned 8 bit integer
• UNSIGNED16 unsigned 16 bit integer
• UNSIGNED32 unsigned 32 bit integer
• SIGNED32 signed 32 bit integer
• INTEGER16 16 bit integer
Code Level (CL)
This is the minimum code level, which is required to access the respective parameter.
To Next Page
Loading...
