Manual 37443A DSLC-2 - Digital Synchronizer and Load Control
Page 18/226 © Woodward
Unpacking
≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡
Before unpacking the control, refer to the inside front cover of this manual for WARNINGS and CAUTIONS. Be
careful when unpacking the control. Check for signs of damage such as bent or dented panels, scratches, loose or
broken parts. If any damage is found, immediately notify the shipper.
Location
≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡
When selecting a location for mounting the DSLC-2 control, consider the following:
• Protect the unit from direct exposure to water or to a condensation-prone environment.
• The continuous operating range of the DSLC-2 control is –40 to +70 °C (–40 to +158 °F).
• Provide adequate ventilation for cooling. Shield the unit from radiant heat sources.
• Do not install near high-voltage, high-current devices.
• Allow adequate space in front of the unit for servicing.
• Do not install where objects can be dropped on the terminals.
• Ground the chassis for proper safety and shielding.
• The control must NOT be mounted on the engine.
To Next Page
Loading...
