Woodward DSLC-2 - Figure 3-19: Toolkit - Interfaces

Manual 37443A DSLC-2 - Digital Synchronizer and Load Control
© Woodward Page 83/226
Menu 5.1 – Interfaces
This menu contains the parameters for the configuration of the interfaces of the DSLC-2.
Figure 3-19: ToolKit – interfaces
Serial Interface 1 – RS-232
The serial interface 1 – RS-232 is mainly used for the configuration tool, ToolKit. This is executed with the
Woodward own Servlink protocol. The RS-232 also allows access by Modbus protocol with fixed parity, stop
bits and full-, halfduplex mode. The unit acts here as a RTU slave.
ID
Parameter
CL
Setting range
Default
Description
3163
Baudrate
2
9.6 / 14.4 /
19.2 / 38.4 /
56.0 / 115.0
kBaud
19.2 kBd
This parameter defines the baud rate for communications. Please
note, that all participants on the bus must use the same baud rate.
3161
Parity
-
fixed
No
-
3162
Stop bits
-
fixed
One
-
3164
Full-, half-
duplex mode
- fixed Halfdup-
lex
-