Woodward DSLC-2 - Modbus Parameters; Serial Interface 1; Serial Interface 2; Network B - Modbus

Manual 37443A DSLC-2 - Digital Synchronizer and Load Control
Page 200/226 © Woodward
Modbus Parameters
≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡
NOTE
The following parameters are available for configuring the Modbus modules on the serial interfaces.
Refer to Chapter: “Configuration & Operation“ for detailed information about all parameters.
Serial Interface 1
Parameter table
ID Text Setting range Default value
Configure RS-232 interfaces: serial interface 1
3185
ModBus Slave ID
0 to 255
1
3186
Reply delay time
0.00 to 1.00 s
0.00 s
Table 10-13: Modbus - serial interface 1 - parameters
Serial Interface 2
Parameter table
ID
Text
Setting range
Default value
Configure RS-485 interfaces: serial interface 2
3188 ModBus Slave ID 0 to 255 1
3189
Reply delay time
0.00 to 2.55 s
0.00 s
Table 10-14: Modbus - serial interface 2 – parameters
Network B – Modbus
Parameter table
ID
Text
Setting range
Default value
Configure TCP/IP Modbus interfaces: Network B
5430
TCP/IP address0
0 to 255
192
5431 TCP/IP address1 0 to 255 168
5432
TCP/IP address2
0 to 255
1
5433
TCP/IP address3 (Device
number of DSLC-2 = 1 to 32)
0 to 255
1
Table 10-15: Modbus - TCP/IP Network B– parameters