Xerox Phaser 3330 Service Manual

Image Quality
Xerox Internal Use Only Phaser 3330 and WorkCentre 3335/3345
Service Manual
3-13
Uneven Density
Print Density is uneven between left and right.
Initial Actions
• Check that the Roller is properly installed.
• Check that the media is dry and in good condition.
• Clean the laser window.
Troubleshooting Reference Table
Troubleshooting Procedure Table
Applicable Parts Example Print
• Toner Cartridge, Refer to Xerox Supplies and
Accessories.
• Transfer Roller (PL3.1A.40, Parts List 3.1A Frame
(2 of 2))
• HVPS (PL3.1A.33, Parts List 3.1A Frame (2 of 2))
Step Actions and Questions Yes No
1. Check the high voltage contacts on the Toner
Cartridge for damage.
The contacts are undamaged.
Go to step 2. Replace the Toner
Cartridge. Refer to Xerox
Supplies and Accessories
2. Replace the Transfer Roller (PL3.1A.40, Parts
List 3.1A Frame (2 of 2))
Does the error persist?
Replace the HVPS
(PL3.1A.33, Parts List
3.1A Frame (2 of 2)).
Complete.
Density Uneven or Wrong (Scan Direction)

Xerox Phaser 3330 Specifications

General

Print Technology	Laser
Print Speed	Up to 42 ppm
Print Resolution	Up to 1200 x 1200 dpi
First Page Out Time	As fast as 6.5 seconds
Monthly Duty Cycle	Up to 80, 000 pages
Standard Paper Capacity	250 sheets
Maximum Paper Capacity	850 sheets
Processor Speed	600 MHz
Memory	256 MB
Paper Output Capacity	150 sheets
Print Languages	PCL 5e, PCL 6, PostScript 3
Operating System Compatibility	Windows, Mac OS, Linux
Connectivity	USB 2.0, Ethernet
Media Sizes Supported	Letter, Legal, Executive, A4, A5
Maximum Paper Size	8.5 x 14 in (Legal)
Weight	10.6 kg