Xerox Phaser 3330

Maintenance
Xerox Internal Use Only Phaser 3330 and WorkCentre 3335/3345
Service Manual
6-7
Adjusting Altitude
Print quality varies with barometric pressure. Since the barometric pressure decreases as the altitude
increases, altitude can affect the print quality. To optimize print quality for your location, select an
altitude setting to match the your location.
To adjust altitude:
For Phaser 3330
1. Select Menu.
2. Use the arrow buttons to select Tools > Setup > Machine Settings > Altitude Adjustment.
3. Select Enable or Disable and press OK.
For 3335/3345
1. Enter the Admin Mode.
2. Press the Log In / Out button.
3. Enter the Username and Password (Defaut Username: admin, Default Password: 1111).
4. Select Device Settings.
5. Select General.
6. Select Altitude Adjustment (On/Off).
Firmware Upgrade Procedure
Upgrade printer firmware using one of two methods:
• Remote using CWIS
• Local using a USB Flash drive
High 3
1
Normal
4
Value
2
High 2
3
High 1
4,000 m
(13,123 ft)
3,000 m
(9,842 ft)
2,000 m
(6,651 ft)
1,000 m
(3,280ft)
s3320-119