Xerox Phaser 3330 Service Manual

Service Parts Disassembly
Phaser 3330 and WorkCentre 3335/3345 Xerox Internal Use Only
Service Manual
4-46
Pick Up Roller
Parts List 3.1A Frame (2 of 2)
WARNING: Do not perform repair activities with the power on or electrical power supplied to the
machine. The machine could activate and cause serious personal injury when the power is on or
electrical power is supplied.
1. Do steps 1-4 in the Preparation section (page 4-3).
2. Undock the printer from the optional Tray 2 Base. (page 4-8).
3. Remove Tray 1 (page 4-6) and the Duplex Unit (page 4-7).
CAUTION: In the next step, be careful not to break the Flag Sensor when removing the Pick Up
Roller
4. Pull the tab down and slide the Pick Up Roller (Parts List 3.1A Frame (2 of 2), PL 3.1A.45) to the
right to remove it.
Note: On the right side of the Pick Up Roller, there is a Pick Up roller bushing. When removing the
Pick Up Roller, be careful to not drop the bushing.
s3320-064
Pick Up Roller
Flag Sensor

Xerox Phaser 3330 Specifications

General

Brand	Xerox
Model	Phaser 3330
Category	Printer
Language	English