Xerox Phaser 3330 Service Manual

Service Parts Disassembly
Xerox Internal Use Only Phaser 3330 and WorkCentre 3335/3345
Service Manual
4-13
Covers and Doors
Front Door
WARNING: Do not perform repair activities with the power on or electrical power supplied to the
machine. The machine could activate and cause serious personal injury when the power is on or
electrical power is supplied.
Parts List 1.0 Phaser 3330 Main
1. Do the preparations (page 4-3).
2. If this printer is on the Optional Tray 2 Base, remove it from the base and disconnect the
Connector CN35 (page 4-8).
3. Remove Tray 1 (page 4-6).
4. Remove the Toner Cartridge and Photoreceptor Drum Cartridge (page 4-5).
CAUTION: If the Front Door is removed, do not attempt to remove the Drum Cartridge without
pulling the black coupling bar (that holds the left side of the Front Door) forward so that it retracts
the pin that holds the Drum Cartridge in place. Attempting to remove the Drum Cartridge without
releasing this pin could result in toner spillage and possible damage to the machine.
5. Disconnect the arm on the left hand side of the printer, release left hook and then the right hook
to remove the Front Door (Parts List 1.0 Phaser 3330 Main, PL 1.3.1).
CAUTION: Do not damage the wires when removing the cover.
6. Loosen or remove the Right Cover (page 4-17)as necessary, to gain access to and then disconnect
the Connector located behind the Right Cover.
Note: Press inward on one side of the cover to release it, then repeat that action to release the
other side
Note: If the Front Door is replaced, the Tag Matrix Label must be peeled off and placed on the
new Front Door.
Rear Door
Parts List 1.0 Phaser 3330 Main
WARNING: Do not perform repair activities with the power on or electrical power supplied to the
machine. The machine could activate and cause serious personal injury when the power is on or
electrical power is supplied.
1. Do steps 1-4 in Preparations (page 4-3)
2. Remove the Duplex Assembly (page 4-7).
3. Open the Rear Door (Parts List 1.0 Phaser 3330 Main, PL 1.0.11).

Xerox Phaser 3330 Specifications

General

Print Technology	Laser
Print Speed	Up to 42 ppm
Print Resolution	Up to 1200 x 1200 dpi
First Page Out Time	As fast as 6.5 seconds
Monthly Duty Cycle	Up to 80, 000 pages
Standard Paper Capacity	250 sheets
Maximum Paper Capacity	850 sheets
Processor Speed	600 MHz
Memory	256 MB
Paper Output Capacity	150 sheets
Print Languages	PCL 5e, PCL 6, PostScript 3
Operating System Compatibility	Windows, Mac OS, Linux
Connectivity	USB 2.0, Ethernet
Media Sizes Supported	Letter, Legal, Executive, A4, A5
Maximum Paper Size	8.5 x 14 in (Legal)
Weight	10.6 kg