Yamaha YZF-R6T - Checking the Connecting Rod and Relay Arms; Installing the Rear Shock Absorber Assembly

4-72
REAR SHOCK ABSORBER ASSEMBLY
CHAS
NOTE:
44 Nm (4.4 mSkg, 32 ftSlb)
44 Nm (4.4 mSkg, 32 ftSlb)
S spring
Damage/wear ! Replace the rear shock ab-
sorber assembly.
S gas cylinder
Damage/gas leaks ! Replace.
S bushings
Damage/wear ! Replace.
S dust seals
Damage/wear ! Replace.
S bolts
Bends/damage/wear ! Replace.
CHECKING THE CONNECTING ROD AND
RELAY ARMS
1. Check:
S connecting rod
1
S relay arms
2
Damage/wear ! Replace.
2. Check:
S bearings
3
S oil seals
4
Damage/pitting ! Replace.
3. Check:
S collars
5
Damage/scratches ! Replace.
EAS00698
INSTALLING THE REAR SHOCK
ABSORBER ASSEMBLY
1. Lubricate:
S spacers
S bearings
Recommended lubricant
Lithium-soap-based grease
2. Install:
S rear shock absorber assembly
When installing the rear shock absorber assem-
bly, lift up the swingarm.
3. Tighten:
S rear shock absorber assembly upper nut
1
S rear shock absorber assembly lower nut
2
Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys
email: info@motomatrix.co.uk