–3–
CABLE ROUTING
SPEC
A Pass the right handlebar switch lead inside the front
brake hoses and over the throttle cables.
B Install the throttle cables to the hook so that the pull-
ing side of the throttle cables is routed downward.
C Pass the clutch cable through the guide.
D Plastic locking tie shall be positioned at 10 mm
(0.39 in.) below from the upper bracket.
E Clamp the left handlebar switch lead to the front fork
with the plastic locking tie and cut the tip of the tie.
Clamp it to the protector section.
1 Right handlebar switch lead
2 Clutch cable
3 Immobilizer unit lead, main switch lead and left han-
dlebar switch lead
4 Throttle cable (return side)
5 Throttle cable (pull side)
6 Front brake hoses
7 Throttle cables
8 Joint
9 Under bracket
CABLE ROUTING
Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys
email: info@motomatrix.co.uk
To Next Page
Loading...
