5-41
Order Job/Part Q’ty Remarks
1
2
3
4
5
Removing the crankshaft position
sensor and pickup rotor
Rider seat
Fuel tank
Right side cowling
Bottom cowling
Engine oil
Generator cover
Clutch cable
Crankshaft position sensor lead coupler
Pickup rotor cover
Pickup rotor cover gasket
Dowel pin
1
1
1
1
2
Remove the parts in the order listed.
Refer to “SEATS” in chapter 3.
Refer to “FUEL TANK” in chapter 3.
Drain.
Refer to “CHANGING THE ENGINE OIL”
in chapter 3.
Refer to “STARTER CLUTCH AND
GENERATOR”.
Disconnect.
Disconnect.
Refer to “COWLINGS” in chapter 3.
10 Nm (1.0 mSkg, 7.2 ftSlb)
15 Nm (1.5 mSkg, 11 ftSlb)
12 Nm (1.2 mSkg, 8.7 ftSlb)
35 Nm (3.5 mSkg, 25 ftSlb)
12 Nm (1.2 mSkg, 8.7 ftSlb)
CRANKSHAFT POSITION SENSOR AND PICKUP ROTOR
ENG
CRANKSHAFT POSITION SENSOR AND PICKUP ROTOR
To Next Page
Loading...
