5-51
CLUTCH
ENG
70 Nm (7.0 mSkg, 51 ftSlb)
NOTE:
EAS00287
CHECKING THE PULL LEVER SHAFT AND
PULL ROD
1. Check:
S pull lever shaft pinion gear teeth
a
S pull rod teeth
b
Damage/wear ! Replace the pull rod and
pull lever shaft pinion gear as a set.
2. Check:
S pull rod bearing
Damage/wear ! Replace.
EAS00299
INSTALLING THE CLUTCH
1. Install:
S thrust plate
1
S clutch boss
2
S lock washer
3
New
S clutch boss nut
4
While holding the clutch boss
2
with the clutch
holding tool
5
, tighten the clutch boss nut.
Universal clutch holder
90890-04089, YM-91042
3. Bend the lock washer tab along a flat side of
the nut.
4. Lubricate:
S friction plates
S clutch plates
(with the recommended lubricant)
Recommended lubricant
Engine oil
To Next Page
Loading...
