4.6 Setup Procedure for Elevator Applications
146 YASKAWA ELECTRIC SIEP C710616 38F YASKAWA AC Drive - L1000A Technical Manual
3. Use a pair of diagonal cutters to cut an opening in the connector cover that allows the cable to pass through. The
cable should pass through the connector cover with the cover fastened to the drive.
Figure 4. 26
Figure 4.31 Reattaching the Connector Cover (1)
4. Slide the connector cover back into place as shown in Figure 4.32.
NOTICE: Make sure the cable does not get pinched between the drive and the connector cover, as this could damage the cable.
Figure 4. 27
Figure 4.32 Reattaching the Connector Cover (2)
Figure 4. 28
Figure 4.33 Drive and Battery Connection Complete
Cut an opening to allow the
battery cable to pass through.
Connect
to battery.
SIEP_C710616_38F_5_0.book 146 ページ ２０１５年１１月９日 月曜日 午後３時３６分
To Next Page
Loading...
