YASKAWA L1000A - Page 147

4.6 Setup Procedure for Elevator Applications
YASKAWA ELECTRIC SIEP C710616 38F YASKAWA AC Drive - L1000A Technical Manual 147
Start-Up Programming & Operation
4
Models CIMR-LU20085 to 20415, CIMR-LU40045 to 40370, 50003 to 50200, and 50032 to 50200
1. Use a Phillips screwdriver to loosen the screw holding the CN19 connector cover in place.
Figure 4.29
Figure 4.34 Removing the CN19 Connector Cover
2. Slide the CN19 connector cover from the drive as shown in Figure 4.35.
Figure 4.30
Figure 4.35 Sliding the CN19 Connector Cover
3. Insert a straight-edge screwdriver into the opening as shown in Figure 4.36, then remove the CN19 connector
cover by sliding it as shown in Figure 4.36.
Figure 4.31
Figure 4.36 Removing the CN19 Connector Cover
Screw
Connector
cover
Phillips screwdriver
SIEP_C710616_38F_5_0.book 147 ページ ２０１５年１１月９日 月曜日 午後３時３６分