Setting Up Your System
83
Configures the local TLS listen port.
Web User Interface:
Settings->SIP->TLS SIP Port
Phone User Interface:
None
To configure NAT traversal and STUN server via web user interface:
1. Click on Network->Advanced.
2. In the NAT block, select the desired value from the pull-down list of Active.
3. Enter the IP address or the domain name of the STUN server in the STUN Server field.
4. Enter the port of the STUN server in the STUN Port(1024~65000) field.
5. Click Confirm to accept the change.
A dialog box pops up to prompt that settings will take effect after a reboot.
6. Click OK to reboot the phone.
To configure NAT traversal for account via web user interface:
1. Click on Account->Register.
2. Select the desired account from the pull-down list of Account.
To Next Page
Loading...
Need help?
General
