14 SECTION 1: CONFIGURING THE WIZARD
To start the Setup Wizard:
1 Click Device Summary > Wizard. The Welcome to the Setup Wizard
Page opens:
Figure 1 Welcome to the Setup Wizard Page
Step 1 - The Setup Wizard Page contains the following sections:
■ System Parameters — Displays parameters for configuring general
device information. The System Parameters are manually configured in
Appendix 1.
■ System Name — Defines the user-defined device name. The field
range is 0-160 characters.
■ System Location — Defines the location where the system is
currently running. The field range is 0-160 characters.
■ System Contact — Defines the name of the contact person. The
field range is 0-160 characters.
■ IP Configuration — Displays parameters for assigning IP addresses.
Packets are forwarded to the default IP when frames are sent to a
remote network. The IP Configuration parameters are manually
configured in Step 3. The section includes the following fields:
■ Method — Indicates if the IP address has been configured
statically or added dynamically. The possible field values are:
■ Manual — Indicates the IP Interface is configured by the user.
To Next Page
Loading...
