1
CONFIGURING THE WIZARD
This section contains information for configuring the Setup wizard. The
3Com Web-based Interface presents a Setup wizard as part of the Device
Summary Section . The Setup wizard enables system administrator
configure basic device settings at the Setup stage or to return and
reconfigure the device settings at any stage. Each step in the wizard
displays a set of parameters that can be manually configured by the
system administrator. The wizard includes the following steps:
■ Step 1 — Viewing Factory Defaults
■ Step 2 — Configuring System Settings
■ Step 3 — Configuring IP Settings
■ Step 4 — Defining Wireless Settings
■ Step 5 — Saving Configured Settings
Step 1 — Viewing
Factory Defaults
The Welcome to the Setup Wizard Page is the first step in the wizard and
it displays a summary of factory default settings. The table displays three
sets of settings: System parameters, IP configuration and Wireless
configuration. Each section is displayed as a step within the wizard.
To Next Page
Loading...
