Defining Bandwidth Settings 251
Defining
Bandwidth Settings
The Bandwidth Summary Page allows network managers to define the
bandwidth settings for a specified egress interface. Modifying queue
scheduling affects the queue settings globally.
Viewing Bandwidth Settings
Queue shaping can be based per queue and/or per interface. Shaping is
determined by the lower specified value. The queue shaping type is
selected in the Bandwidth Summary Page.
To view Bandwidth Settings:
1 Click Policy > QoS General > Bandwidth > Summary. The Bandwidth
Summary Page opens:
Figure 130 Bandwidth Summary Page
The Bandwidth Summary Page contains the following fields:
■ Interface — Displays the interface for which the global QoS
parameters are defined.
■ Ingress Rate Limit Status — Indicates if rate limiting is defined on
the interface. The field range is 1-1,000,000 kbits per second.
The
possible field values are:
■ Enable — Enables ingress rate limiting on the interface.
■ Disable — Disables ingress rate limiting on the interface.
To Next Page
Loading...
