2
GETTING STARTED
This section provides an introduction to the user interface, and includes
the following topics:
■ Starting the 3Com Embedded Web Interface
■ Understanding the 3Com Embedded Web Interface
■ Saving the Configuration
■ Resetting the Device
■ Restoring Factory Defaults
■ Logging Off the Device
Starting the 3Com
Embedded Web
Interface
Disable the popup blocker before beginning device configuration using
the EWS.
This section contains information on starting the 3Com Embedded Web
interface. To access the 3Com user interface:
1 Open an Internet browser.
2 Ensure that pop-up blockers are disabled. If pop-up blockers are enable,
edit, add, and device information messages may not open.
3 Enter the device IP address in the address bar and press Enter. The Enter
Network Password Page opens:
To Next Page
