168 CHAPTER 8: DEFINING WLAN
Mitigating Rogue
Handling
The Rogue Handling Mitigate Page allows network managers to
configure WLAN mitigation. Deleting a rogue AP does not mitigate or
suppress the rogue. If the rogue AP is still physically present and active, it
will still appear in the Rogue Access Point list after scanning for rogue
APs.
To configure Rogue Mitigation:
1 Click Wireless > Rogue Handling > Mitigate. The Rogue Handling
Mitigate Page opens:
Figure 84 Rogue Handling Mitigate Page
The Rogue Handling Mitigate Page contains the following fields:
■ Sort by — Defines the parameter that will be applied to displaying
the table. The possible field values are:
■ SSID — Sorts according to the access point Service Set IDentifier
(SSID) associated with the rogue. The SSID is the name of the ESS
to which the transceiver belongs.
■ Status — Sorts according to the Rogue status.
■ Mac Address — Sorts according to the MAC address associated
with the rogue WLAN device.
■ Radio — Sorts according to the selected Radio Interface.
To Next Page
Loading...
