222 CHAPTER 11: CONFIGURING SPANNING TREE
Configuring Classic
Spanning Tree
To configure Classic STP Setup:
1 Click Policy > Spanning Tree > Classic STP > Setup. The Classic STP
Setup Page opens:
Figure 115 Classic STP Setup Page
The Classic STP Setup Page contains the following fields:
■ Global Settings
■ Bridge Settings
■ Designated Root Settings
Global Setting Parameters
■ Spanning Tree State — Indicates whether STP is enabled on the
device. The possible field values are:
■ Enable — Enables STP on the device.
■ Disable — Disables STP on the device.
■ STP Operation Mode — Specifies the STP mode that is enabled on
the device. The possible field values are:
To Next Page
Loading...
