252 CHAPTER 12: CONFIGURING QUALITY OF SERVICE
■ Egress Shaping Rates — Configures the traffic shaping type for
selected interfaces. The possible field values are:
■ Status — Defines the shaping status.
■ CIR — Defines CIR as the queue shaping type. The possible field
range is 64-1,000,000,000 kbits per second.
■ CbS — Defines CbS as the queue shaping type. The possible field
range is 4096-16,769,020 kbits per second.
To configure Bandwidth Settings:
1 Click Policy > QoS General > Bandwidth > Setup. The Bandwidth
Setup Page opens:
Figure 131 Bandwidth Setup Page
The Bandwidth Setup Page contains the following fields:
■ Interface — Displays the interface for which the global QoS
parameters are defined. The possible values are:
■ Port — Selects the port for which the global QoS parameters are
defined.
■ LAG — Selects the LAG for which the global QoS parameters are
defined.
■ Enable Ingress Rate Limit — Enables setting an Ingress Rate Limit.
■ Ingress Rate Limit — Indicates the traffic limit for the port.
To Next Page
Loading...
